Monday, February 13, 2012

How to Set Your Quartz Cuckoo Clock

There have been some changes to the quartz cuckoo clock movements. The new models don't have the cumbersome "eye" or light sensor, but rather a more sophisticated night-off system. The newer clocks also have nicer music!

In order to properly set up your new quartz cuckoo clock, there are a few things to take note of. The proper set-up procedure is already in your printed instructions, and here, but please also reference this article to troubleshoot.

The point of the setup procedure is to FIRST properly align the chiming computer mechanism with the clock hands, and SECOND to set the correct time on your clock hands. In order to do this, you'll need to find out what time your bird thinks it is. Once you have the batteries installed, move the longer minute hand only (don't touch the shorter hour hand) clockwise until the hour is reached. Please make sure you have the cuckoo switched on before taking this step.

Once the hour is reached, count the number of times the cuckoo calls. Keep in mind, that each cuckoo call is followed by an echo - in other words: you should only count the first LOUDER "cuckoo" of each set. The softer echo call is not meant to be counted.

If you did not hear any cuckoo call, you are probably in the nighttime or PM setting. Keep going around with the minute hand until the cuckoo will call again. You need to get back on to the AM setting so that you can hear the bird.

Once you have counted the amount of calls, compare it to what the hands say. If, for example, the clock cuckooed 9 times and the hands show 7:00 you'll need to push the setting button twice to realign the movement with the hands. If your clock is calling 11 times and your hands show 6:00, then press the button once (7:00) twice (8:00) three times (9:00) four times (10:00) and finally five times to reset the computer to synchronize the chime with the hands. In other words you'll have to tell the computer to catch up to the hands.

If your clock calls 6 times, and your hands show 5:00, you'll need to push the button 11 times.

An alternative method of aligning the computer with the hands would be to simply move the hour (shorter) hand independently to match the number of calls counted. This is the same procedure used on mechanical clocks.

Remember, you can only make this synchronization when the clock is in the daytime hours. If, at any time during this phase of the setup your clock does not make any cuckoo calls DON'T PANIC. You are probably in the PM time range, and will simply have to advance the minute hand a few hours so that the clock will cuckoo again.

Once your computer and hands are synced up, you can set the time as usual. Simply move the minute hand around until the correct time is reached. NOTE: You don't have to wait at each hour for the music to finish. Once the bird and hands are synchronized, they will remember where the hands are pointing.

You will probably have to realign using this simple procedure every time you change the batteries.

Troubleshooting FAQ:

Sometimes my cuckoo doesn't cuckoo at all, or at least not when it should.
A: Your clock is probably in the nighttime range. These clocks are meant to be silent between approximately 10pm and 8 or 9am. Simply move your minute hand (so that the hour hand follows) clockwise several hours until your clock starts cuckooing again. Now you are in the daytime range.

My cuckoo clock is cuckooing way too many times. Sometimes it cuckoos 15 times!
A: Remember that your quartz cuckoo has an echo. There are other sounds playing too, for example there is another kind of bird that starts the hour chime, then the cuckoo, his echo, and music. Be sure to only count the louder cuckoo calls - without their echos.

My quartz cuckoo clock isn't cuckooing the correct number of times. How do I sync the bird with the hands?
A: There are two methods for this. You could press the setting button a number of times equaling the difference between what the hands show and what the bird is calling. Count the number of calls first, then push the button to bring it up to what the hands say. You could also move the hour hand (independently of the minute hand) to match the number of calls the bird makes.

Remember to follow our blog and on Twitter for continuous product updates and troubleshooting tips. We also have many helpful articles on our /instructions page on our main website www.NorthCoastImports.com.

1 comment:

  1. Sanjay7:37 AM

    My new quartz cuckoo clock chimes only once after setting but after that it never chimes. I bought it a week ago from Black Forest area in Germany from Drubba Shop. Can anyone resolve this issue. We are staying in Muscat and there is no service center in Muscat.

    ReplyDelete